This version of the GovReg allows for inline use of the product. Usually you would connect a GovReg to a Sanke coupler, ball lock disconnect or pin lock disconnect. If you have a specific situation where you want to put a GovReg inline or just want to cut a line and put it in between you can use this configuration. Both ends can be used for 5/16 or 3/8 ID gas line. Keep in mind that in the beverage industry fittings that are called 5/16 are often actually 3/8, but this will not effect fit.
- Both ends are 5/16" or 3/8" ID line compatible
- GovRegs normally are set for 12PSI, but we can set it to a different pressure. Please make a note in the notes section of the order AND email shipping@kegconnection.com with the pressure you want.
- GovRegs can be adjusted from 4PSI to 45PSI by using a GovReg Adjuster Tool
Check out our videos on the GovReg:
Adjusting the GovReg® Inline Secondary Regulator | How To Video (Click Here)
Converting My Keezer Using GovReg® Secondary Regulators | DIY Project (Click Here)
The GovReg® Secondary Regulator | Product Showcase (Click Here)
